Dilatometers from BAHR
Dilatometers are used for measuring the thermal deformation of materials within a known temperature regime. Bahr dilatometers are available with many features for measuring single samples, differential measurements, multiple samples, and quench/deformation systems. There are systems capable of high heating and cooling rates and full Isotherm plots.
Differential Scanning Calorimeter (DSC) from BAHR
The new generation DSC from Bahr has a thermally decoupled heat flux sensor which provide a high thermal resistance between sensor and heating faces. This, in turn enables a high resolution of successive reactions.
Thermal Gravimetric Analyser (TGA) from BAHR
The Bahr Thermal Gravimetric Analyser (TGA) measures the change in mass of a sample as a function of temperature. Bahr systems cover the wide range of -160 to 2400 degrees C. The balance is located below the sample, providing high sensitivity, stable behaviour with dynamic gas flow and excellent long term stability at high temperatures.
There is also a lateral balance system which is designed to have an even higher degree of stability under dynamic gas conditions.
Simultaneous Thermal Analyser (STA) from BAHR
Simultaneous Thermal Analysers measures the change of mass and temperature of a sample as a function of the temperature. The Bahr side weighing system is extremely stable under a dynamic gas load, and because of the small sample volume, the system is very well suited for later analsis by FTIR or MS.
Thermo Mechanical/Dynamic Mechanical Analyser (TMA/DMA) from BAHR
Bahr Thermo/Dynamic Mechanical Analysers measure the change in sample due to temperature and applied load, either static or dynamic, at tensile or compressive rates from 0.05 to 50 Hz. Various measuring systems are available, depending on application.
The inductive sensor has a resolution of 10nm and several calibration standards are available, depending on application.
High Temperature Viscometer from BAHR
Bahr Viscometry systems cover the range of requirements for high temperature analysis - rotational, fibre elongation and beam bending systems for measuring the dynamic viscosity of materials. The system is designed for measuring the viscosity of materials up to 1700°C. Typical materials are glasses, light metals, slags, mould powders, etc
Plastometer from BAHR
The Bahr Plastometer enables the measurement of the plastic deformation behaviour of metallic solids as a function of temperature, applied force (amplitude and frequency) as well as compressive and/or tensile forces. A gas shower quench after deformation allows for extremely fast cooling.
